Iei-integration WAFER-CV-D25501_N26001 User Manual download pdf (Page 74)

WAFER-CV-D25501/N26001 3.5" Motherboard

Page 59

Step 3: Insert the LAN cable RJ-45 connector. Once aligned, gently insert the LAN

cable RJ-45 connector into the on-board RJ-45 connector.

4.7.2 Serial Device Connection

The WAFER-CV-D25501/N26001 has a single male DB-9 connector on the external

peripheral interface panel for a serial device. Follow the steps below to connect a serial

device to the WAFER-CV-D25501/N26001.

Step 1: Locate the DB-9 connector. The location of the DB-9 connector is shown in

Chapter 3.

Step 2: Insert the serial connector. Insert the DB-9 connector of a serial device into

the DB-9 connector on the external peripheral interface. See

Figure 4-20.

Figure 4-20: Serial Device Connector

Step 3: Secure the connector. Secure the serial device connector to the external

interface by tightening the two retention screws on either side of the connector.

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 180 181

No comments

Iei-integration WAFER-CV-D25501_N26001 User Manual Page 74